Co2 Reactor

Lighting, filtration etc
User avatar
Jamie G
Posts: 443
Joined: Mon Dec 29, 2003 6:49 pm
Location: Crofton, MD
Contact:

Post by Jamie G »

I have made a version of GG's reactor, but I am using plastic dish scrubbers instead of bioballs. Although I am not airlocking my canister filter, it blows out the bubbles thru the filter. Is this normal ? or should the reactor dissolve the co2 air ? It makes the tank a little unsightly with all the bubbles being blown around ... plus they collect at the top under the scumline.   <img border="0" src="smileys/smiley11.gif" border="0">
User avatar
Ghazanfar Ghori
Site Admin
Posts: 3258
Joined: Sun Nov 23, 2003 5:26 am
Location: United States

Post by Ghazanfar Ghori »

You've rigged it up correctly? With the water entering
from the top of the reactor and existing the bottom and
the reactor mounted vertically?
-
Ghazanfar Ghori

Image
User avatar
Jamie G
Posts: 443
Joined: Mon Dec 29, 2003 6:49 pm
Location: Crofton, MD
Contact:

Post by Jamie G »

yup, i dont know whats up. every once in a while, it sounds like it drains out and i can hear the h20 running back into it
User avatar
Ghazanfar Ghori
Site Admin
Posts: 3258
Joined: Sun Nov 23, 2003 5:26 am
Location: United States

Post by Ghazanfar Ghori »

What rate are you adding CO2 to it? What the flow
rate on the filter?
-
Ghazanfar Ghori

Image
User avatar
Jamie G
Posts: 443
Joined: Mon Dec 29, 2003 6:49 pm
Location: Crofton, MD
Contact:

Post by Jamie G »

about 1 bubble/ 2seconds. im unsure of the flow rate ..
its the Eheim 2215.     1 bbl makes tiny bubbles .. any more and theyre lots of medium sized
User avatar
Ghazanfar Ghori
Site Admin
Posts: 3258
Joined: Sun Nov 23, 2003 5:26 am
Location: United States

Post by Ghazanfar Ghori »

Have you checked your CO2 levels?
-
Ghazanfar Ghori

Image
User avatar
Jamie G
Posts: 443
Joined: Mon Dec 29, 2003 6:49 pm
Location: Crofton, MD
Contact:

Post by Jamie G »

negative on that ghostrider .. just ordered test kits today .. but not a co2 test .. isint there a way to figure it from ph and hardness ??
User avatar
Ghazanfar Ghori
Site Admin
Posts: 3258
Joined: Sun Nov 23, 2003 5:26 am
Location: United States

Post by Ghazanfar Ghori »

-
Ghazanfar Ghori

Image
User avatar
Cristy Keister
Posts: 2124
Joined: Sat Nov 29, 2003 6:52 am
Location: MD

Post by Cristy Keister »

Also check your connections are tight enough, make sure that air isnt' getting sucked in. That happened with mine on the 1st try.
User avatar
Jamie G
Posts: 443
Joined: Mon Dec 29, 2003 6:49 pm
Location: Crofton, MD
Contact:

Post by Jamie G »

I thought of that as well .. and checked .. but theyre sealed.
Post Reply

Sponsors